American Access Systems Touch Plate Reader - 11-3500 - Manual (Page 8)

Page 8 American Access Systems / Security Brands, Inc.
Door Unlock Mode
The relay may be set to stay latched (door unlocked) during periods when access control is unwanted. While in the
“DOOR UNLOCK” mode, the relay stays activated, and the LED indicator will flash green approximately once every
second. The unit may not be programmed with the programming deck, nor will it recognize access cards while in
the “DOOR UNLOCK” mode. To set the unit to the “DOOR UNLOCK” mode, place the “*” (THRU) card on the TOUCH
CARD® reader plate, remove it and place the “ACTIVE/INACTIVE” card on the TOUCH CARD® reader plate and
remove it.
* + ACTIVE/INACTIVE
To return the 11-3500 to normal operation, place the “ACTIVE/INACTIVE” card on the TOUCH CARD® reader plate
and remove it.
Timed Antipassback Feature
If the Timed Antipassback feature is activated, a card used for entry is made temporarily void for a settable amount
of waiting time. The purpose of this feature is to deter a user from “passing back” his card to another for unauthorized
entry. When this feature is activated, the maximum ID number that the unit will accept is 1750. When this feature is
deactivated, the maximum ID number is 3500.
If you activate the Timed Antipassback feature, cards with ID numbers greater than 1750 will no longer be recognized
by the unit. The status (Void or Valid) of cards with ID numbers of 1750 or less will remain unchanged. Once activated,
you must set an antipassback waiting time for this feature to be functional (See below).
To activate the Timed Antipassback feature, place the “*” (THRU) card on the TOUCH CARD® reader plate and
remove it. Then place the “SET TIMER” card on the TOUCH CARD® reader plate and remove it. Then place the
“VALID” card on the TOUCH CARD® reader plate and remove it.
0 + * + SET TIMER
Antipassback Waiting Time
The antipassback waiting time may be set to any number of minutes from 1 to 30. However, the actual waiting time
will fluctuate between the time set and twice the time set. Thus, if the antipassback time is set to 5 minutes, users
will have to wait a minimum of 5 minutes and a maximum of 10 minutes before reentry will be allowed. Setting the
antipassback waiting time to 0 will disable the Antipassback feature and reentry will be allowed immediately. See
above to re-activate the Antipassback feature.
To set the antipassback waiting time, place on the TOUCH CARD® reader plate the sequence of cards representing
the number of minutes of the minimum waiting period (1 to 30), then place the “*” card on the TOUCH CARD®
reader place and remove it, then place the “SET TIMER” card on the TOUCH CARD® reader plate and remove it.
Example: Set antipassback waiting time to 3 minutes.
Place the “3” card on the TOUCH CARD® reader plate, remove it, and place the “*” on the TOUCH CARD® reader
plate, remove it, and place the “SET TIMER” card on the TOUCH CARD® reader plate, and remove it.
3 + * + SET TIMER
SecuRelayTM Mode. 26SA units with firmware version 4.0 or higher may be used with the SecuRelayTM for increased
vandal resistance.
To place the unit in the SecuRelayTM mode, place the “*” card on the reader twice, followed by the “8” card.
* + * + 8
To return to normal mode, place the “*” card on the reader twice followed by the “1” card.