Citizen Systems Citizen CLP 6001 CLP-6001 - Manual (Page 48)

4-5
Indication Description Corrective actions
OverHeat
Cooling Head overheat Wait until the head temperature goes down.
When the temperature becomes low, the
remaining printing resumes.
Stop Stop key pressed Enters a pause after displaying the stop by the
Stop key.
If the Pause key is pressed, the printing will
resume.
If the Stop key is pressed again, the stored
printing contents will be lost and "on line" will
turn on.
Cancel Stop command
reception
(communication
control) Displays the stop by the stop command,
discards the stored printing contents, and
enters a pause.
If the Pause key is pressed, "on line" will turn
on.
HeadOpen Mechanism head
open Close the mechanism head.
PaperEnd Paper end (no paper
left) Install the paper.
PaperErr Paper out (paper
position can't be
detected) Check the contents and clear with the Stop
key.
Correct the faulty setting of the paper detection
(paper gap, black line, continuous paper).
Correct the faulty parameter for paper (max.
length, continuous paper).
Adjust the sensor or change for the paper that
accepts the paper position detection.
Specify the length for detection miss checking
with the M command.
When the paper position can't be detected
during paper feeding by the specified length, it
is judged error.
Generally specify the length
about three times the label length.
In case of the continuous paper, specify the
label length with the C c ommand.
Difference between the maximum and
minimum values of the sensor reading voltage
must be 0.8 V or more.
Sensor adjustments and paper characteristic
verification (voltage verification) can be
performed with the Maintenance mode.