Citizen Systems Citizen CLP 6001 CLP-6001 - Manual (Page 77)

6-18
•
Initialization parameter values
Initialization values for print or tear position are described below by each
operating mode.
In Native ON Unit: mm (inch)
Normal
print
Auto-cutter Peeling Tear-off
Minimum
value
Print position
(Onnnn, form offset)
55.9(2.2)
  
12.7(0.5)
Tear position
(fnnn, feed offset)
55.9(2.2) 86.3(3.40) 68.5(2.7) 73.5(2.9) 12.7(0.5)
If values lower than the minimum value are set, the initialization value will be
set.
In Native OFF Unit: mm (inch)
Normal
print
Auto-ı cutter Peeling Tear-off
Minimum
value
Print position
(Onnnn, form offset)
27.9(1.1)
  
12.7(0.5)
Tear position
(fnnn, feed offset)
27.9(1.1) 58.3(2.3) 37.0(1.46) 42.1(1.66) 12.7(0.5)
If values lower than the minimum value are set, the initialization value will be set.
6.5.6 When "fnnn" command is executed while tear-off is OFF
Even with the tear-off OFF, the paper will be fed to the "fnnn"-specified position
after printing if an "fnnn > Onnnn" value is set by using the "fnnn" command.
This function can be used in such cases as another device is incorporated in the
printer.
When operating with the FARGO, the following is different from those in the
tear-off ON:
• The paper is fed immediately after printing, whereas, in the tear-off ON the
paper is fed when no data is transmitted for 0.5 second after printing.
However, if the next print data is transmitted during printing, the printer will
start printing without feed or back-feed.