Kenwood KR-V5560 - Manual (Page 2)

aution: head this page carefuhv to ensure sa ЪжпаатФП
Units are designed for operation as follows.
U.S.A. Mexico and Canada___ __________________ J20 V only
Australia................... ............................................... only
Other countries... ..110-120/220-240 Vswitc
AC voitage sefection
This unit operates on 110 - 120 volts or 220 - 240 volts
AC. The AC voltage selector switciTon the rear panel is
set to the voltage that prevails in the area to which the
unit is shipped. Before connecting the power cord to your
AC outlet make sure that the setting position of this
switch matches your line voltage. If not, it must be set to
your voltage in accordance with the following direction.
Our warranty does not cover damage caused by excessive line volt­
age due to improper setting of the AC Voltage selector switch.
AC voltage selector switch
Move switch lever to match your line voltage
with a small screwdriver or other pointed tool.
Mofeta precautions
WARNING TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION; TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER
[OR ВАСЮ. NOUSER-SERVICEABLEPARTSINSIDE, REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL. WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNTNSULATED "DANGEROUS VOLTAGE"
WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS. A
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERTTHE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE [SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE,
FortheU.S.A.
FCC WARNiNG
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
.
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
— Consult the dealer or an experienced radio / TV technician for help.
FortheU.S.A.
Note to CA TV system instaher:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of
cable entry as practical.