Standybymode of power switch, Tni-mimìmiwltifilcai – Kenwood KR-V5560 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tni-MiMìMIWltifilcai:
s
L!NE STRAIGHT
indicator
Reception mode tndicator
OTOÑE control knobs
ONumeríc keys
ORemote control sensor
OMUTING indicator
0STAND BY indicator
©BAND key
Press to switch the broadcast band.
OTUNING keys
Press to tune broadcast stations.
©P.CALL key
Press to recall a preset station.
0AUTO key
Press to select the auto tuning mode.
©VOLUME CONTROL knob
©POWER key
©PHONES jack
Used for headphone listening.
©SPEAKERS A/B keys
Press to select the A and/or B speaker sys
tems.
©TEST TONE key
©LOUDNESS key
Press to enhance low frequencies.
©DOLBY PRO LOGIC key
©CENTER MODE key
Press to select the center mode of the
DOLBY PRO LOGIC surround play.
©DOLBY 3 STEREO key
©CENTER LEVEL key
©BYPASS key
Press to cancel the surround modes.
© REAR LEVEL key
©LINE STRAIGHT key
Press to reproduce the source with a highei
sound quality.
©DELAY TIME key
Press to adjust delay time.
©TAPE 2 {MONITOR) key
©INPUT SELECTOR knob
Turn to select the input sources.
©MEMORY key
Press to preset a station in the memory.
©DIRECT key
Press for direct station tuning based oi
numerical input.
© BALANCE control knob
Turn to adjust the volume balance between
left and right.
STANDYBYmode of POWER switch
When the power cord of this system is plugged into an AC outlet, the STAND BY indicator lights up regardless of. the ON/OFF setting ofthc
POWER switch. This indicates that a small amount of current is being supplied to the unit to back up the memory contents. This mode is referred;
to as the Stand By mode. While the STAND BY indicator is lit the power of the system can be switched ON/OFF from the remote control unit.