Toshiba KV-9096A - Manual (Page 21)

Notes: -------------------------------------------------------------------------------------------------------------------------------------------------
In the cases shown below, Alarm Memory search may be not carried out.
■ If the alarm recording is not carried out for more than those listed in the following chart then, the alarm may be skipped.
■ If the alarm recording interval is not left for more than those listed in the following chart then, the alarm may be skipped.
■ If there is not enough time between the beginning of the alarm search and the first alarm activation. If the time period is shorter
than those listed in the following chart then, the first alarm may be skipped.
Record
mode
Minimum alarm recording
time needed
Minimum aiarm recording
intervai needed
Minimum recording time needed between
start of search and first aiarm activations
SPA2 or EPA6 2 s 7s 5 s
SPA12 15s 50 s 35 s
EPA18 7 s 25 s 15 s
SPA24 30 s 95 s 65 s
Tape Remain
p
<
DC
<
Q.
LU
DC
Q.
z
o
When the TAPE REMAIN button is depressed during recording or playback, the counter display changes to the remaining tape
display. The remaining time is the approximately estimated time in the SPA2 mode to tape end.
I LI D n
I I I _l LI
0 ~i
1 I L
TAPE REMAIN
CD
• The remaining time is the approximate remaining time.
• Displays the remaining tape time estimated in the SPA2 mode.
During computation of the remaining time, the following display appears.
loa
► L - _» n c
• When the VCR has been used in the recording mode over a long period, it may take considerable time for computation. When
operating at fast speed in the SPA2 mode, the computation is faster.
Note: ----------------------------------------------------------------------------------------------------------------------------------------------------
It is possible to compute the remaining time for T-120, T-90, T-60 and T-30 tape. The display will not be correct for other kinds of
tape.
Error Message
When an abnormality occurs during operation, the error code is displayed.
At the same time, the buzzer will sound continuously.
0 J
1 I L
• When the error code “E-1 ” to “E-4” are
displayed, consult with your dealer.
• When the error code “E-5” is displayed,
the tape is cut. Replace with a new tape.
Code Number Condition of Abnormaiity
E-1 Abnormality on reel rotation during tape running.
E-3 Abnormality on cylinder rotation during recording and playback.
E-4 Abnormality on tape loading mechanism.
E-5 Video tape is cut.
E-8 Dew condensation.
20