Toshiba KV-9096A - Manual (Page 9)

A Word on the Exclusive 3N-100AAS Specification of Battery
Battery Pack
■ Temperature
The nickel-cadmium battery pack (3N-100AAS) is used for
power source of the built-in clock and memory circuit.
Charging the Battery Pack
1. Turn on the power of the VCR.
2. The battery pack in the VCR is charged.
Battery Installation
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
For charging
For operating
For storing
■ Charging time
Notes: -----------
0°C to 80°C
-20°C to 80°C
-30°C to 80°C
more than 48 hours
O
3
Q
O
OC
Use only for this VCR.
Do not dispose of the batteries into fire.
Do not short circuit the terminals.
Do not modify or disassemble.
Avoid dropping, unnecessary shocks.
RED wire
Installation:
1. Install the battery pack placing the red wire upside, and
connect the connector on the battery pack to this VCR.
Make sure the polarities (-i-) and (-) are correct.
2. Close the battery cover.
Note: ----------------------------------------------------------------
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.
8