Toshiba TEC MA-1700 - Manual (Page 127)

EOI-11040
CUSTOMER FILE CODE (CHECK TRACK NO.) OPENING OR CLOSING
(Submode 15)
This program is available only when the ‘Check Track" option is
selected. Programming is allowed any time outside a sale.
Mode Lock ; SET / GT Lock ; Neutral
Opening :
15 (@/FORl Customer File Code t (#1
(
Max.
1 to I
6 digits;
999999
> lATH-Ll
Repeatable for different codes to be opened
NOTES : 1. The Customer File codes that have been opened in this program will be
accessed by entering the code and depressing the [PICK UP BAL] key
for sale entry in a charge posting operation in the “REG** or “MGR**
mode. At this time, the balance of the new customer assigned with the
code will show zero which will be printed as the previous balance line
item. On fmalizing the sale, the new balance will be printed at the
bottom of the receipt, which will be stored in the same Customer File
Code memory area. Thus the operator always uses the [PICK UP
BAL] key for both starting a new customer*s account and recalling the
customer's balance.
2. If all the opened Customer File codes are used up and a new customer
file code is required to be opened during the business hours, the [CODE
OPEN} key may be used. When a new code is entered, followed by
[CODE OPEN], the code is printed as the previous balance line item
with the balance zero on the receipt, and at the same time, the code is
added to the list of the Customer File Codes opened in the above “SET**
mode operation. However, the use of the [CODE OPEN] key can be
programmed to require Manager intervention, which can control the
operator*s opening of a new customer file code outside the list of
Customer File Codes pre^opened in the “SET** mode.
3. A maximum of 1000 Customer File Codes may be opened (max. 1000
fixed).
ex.) To open the folloeing customer file codes.
Code to be opened
1
104
105
Mode Lock to SET
15 [@/FOR]
1l#l
104 l#J
105 m
[AT/TL]
F- 15
#000001
#000104
#000105
0003
0030 IISIITH
6 9 -