Toshiba TEC MA-1700 - Manual (Page 16)

EOI-11040
6.2 CASHIER KEY METHOD (Push-stay Cashier Keys)
Push-stay Cashier Keys
№
Light lo indicate
4 ON*siatu8
G ) Q ® Q
Cashier keys 1 to 4 Cashier Locks 1 to 4
Each key is assigned to each cashier. The register will not operate in the "REG”, “MGR”, or
"El”
mode unless one of these keys is inserted and pushed on or pushed-and-locked at the corresponding
Cashier Lock. The light is lit when the key is in the ON-stalus.
Each of the keys may be inserted and pulled out in the neutral position marked with “1" to “4” in the
above figure, and two ways are provided to set the Cashier Key to ON status:
PUSH-ON
When simply pushed on and released, the Cashier Key is set to ON status. This ON condition
wilt be cleared by any of the following operations:
1) when no key-in operations follow in three seconds.
2) when the transaction is finalized.
3) when another Cashier Key is pushed-on when outside a sale.
4) when the Mode Lock is turned to another position.
PUSH-AND LOCK
When pushed and turned to the right, the ON status is locked until it is turned back to release and
another Cashier Key is set to ON.
When another Cashier Key is attempted to push-and-lock, the register will entirely be locked.
If a Cashier Key has already been set to ON and a sale is under way, another Cashier Key will be
disregarded of attempted to ON.
NOTE : To select the multi-drawer feature, the cashier key method must be adopted instead of the
signing method.
-
10 -