Power failure process, Journal and receipt paper-end detector – Toshiba TEC MA-1700 User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11040
10. POWER FAILURE PROCESS
If a power failure occurs, the sales memory is protected by the back-up battery; registration and
printing will normally be performed on regaining the power. However, please note the following cases:
(1)
The printer will work to print the entered data without failure after the power recovery if any data
was being printed. However, one extra line may be fed on the power recovery depending on the
power failure timing.
(2) The following are displayed indications on the power recovery :
ECR CONDITION at the time of Power Failure
DISPLAY INDICATION on
the Power Recovery
OUTSIDE A
SALE.
No Key-in has been operated.
Displays zero. Operations may
go on.
Numeric or Declaration Keys (such as [RTN
MDSE], [PR OPEN], etc) have been entered
but not motorized keys.
Displays "FAIL". Depress fC]
to clear the error condition, and
re-start the operation from the
numeric or declaration key entry.
DURING A
SALE.
No Numeric or Declaration keys have been
entered.
Regains the display content that
was obtained just before the
power failure. The operations
may be continued.
Numeric or Declaration keys have been
entered.
Displays "FAIL". Defxess (CJ
to dear the error condition, and
re-start the operation from the
numeric or declaration key entry.
If a power failure occurs, it is recommended to check the receipt print content before the receipt
is handed to the customer.
11. JOURNAL AND RECEIPT PAPER-END DETECTOR
(1)
This detects when either the journal or receipt paper is running out. It is provided to prompt the
operator to replace the old paper roll with a new one.
(2)
When the paper roll is running out (or the paper has not been set properly), no key operation is
accepted and the AMOUNT portion of the display keeps flickering.
(3)
When a new paper roll is set, only the [RF] and [JF] keys are allowed to operate. Next, when
the |C] key is depressed, the display flickering will be cleared and normal key-in operations will
be accept^. When any printing has been suspended, it will continue printing.
(4)
If this detector senses a paper-end condition during printing, the printing stops after the current
line printing is completed.
(5)
If the [C] key is depressed in the paper-end condition, it is ignored. The [C] key depression will
clear the display flickering only after the new paper roll is set.
-51
-