COMEUP Automotive Winch (Ver:00) - Manual (Page 14)

Winching Procedures
13
X Preparation before Winching
1). Connect the remote control
Always disconnect the remote control when not in use.
Always have the remote control kept free from winch,
wire/synthetic rope and roller/hawse fairlead.
2
2). Disengage clutch function
Lift the clutch T-handle up and turn it at 90°
counter-clockwise rotation to the “Disengaged” position,
rope can now clutch off the drum.
3). Pull the wire/synthetic rope to the anchor point
Wear leather gloves when handling wire/synthetic rope.
Pull out enough rope to reach the anchor point. Be careful
to keep the rope under tension.
4). Engage clutch function
To engage, lift the clutch T-handle up and turn it at 90°
clockwise rotation to the “Engaged” position. Never engage
the clutch while the drum is rotating.
X Winching Operation
1). Check the wire/synthetic rope
Before winching, make sure the rope is wound on the drum
evenly. If there is a mixed winding, it is essential to rewind
it evenly.
2). Lay a recovery damper over the rope near the hook
end.
If a wire/synthetic rope failure occurs, the damper can
prevent the rope from whipping.