Ecler CA‐NET RS‐232 User Manual
Page 24
CA‐NET Protocol
page 24 / 29
TALKOVER_DEPTH
<Input=I4:I5>
<Depth=dBx10>
Sets the current TALKOVER DEPTH (attenuation, dBx10) for the
specified INPUT
TALKOVER_ATTACK
<Input=I4:I5>
<AttackTime=msx10>
Sets the current TALKOVER ATTACK TIME (milliseconds x10) for the
specified INPUT
TALKOVER_HOLD
<Input=I4:I5>
<HoldTime=msx10>
Sets the current TALKOVER HOLD TIME (milliseconds x10) for the
specified INPUT
TALKOVER_RELEASE
<Input=I4:I5>
<ReleaseTime=msx10>
Sets the current TALKOVER RELEASE TIME (milliseconds x10) for the
specified INPUT
CHIME_MELODY
<Input=I4:I5>
<ChimeMelody>
Sets the current CHIME MELODY selected for the TALKOVER
function in PAGER mode
CHIME_VOL
<Input=I4:I5>
<Volume=dBx10>
Sets the current CHIME MELODY VOLUME (dBx10) adjusted for the
TALKOVER function in PAGER mode
XSELECT
<Input=I1:I5>
<Zone=ZA:ZD>
ON/OFF
Sets the current CROSSPOINT SELECT status (ON (input active) or
OFF (input muted)) for the specified INPUT at the specified output
zone
XLEVEL
<Input=I1:I5>
<Zone=ZA:ZD>
<Level=0:99>
Sets the current CROSSPOINT LEVEL (mix level) for the specified
INPUT at the specified output zone
ZONE_LABEL
<Zone=ZA:ZD>
“<Label>”
Sets the current LABEL (name) for the specified output zone
(between quotation marks to allow for blank characters in the label)
ZONE_STEREO
<Zone=ZA:ZD>
ON/OFF
Sets the current STEREO link status (ON or OFF) the specified output
zone
ZONE_MUTE
<Zone=ZA:ZD>
ON/OFF
Sets the current MUTE status (ON or OFF) for the specified output
zone
ZONE_VOL
<Zone=ZA:ZD>
<Volume=0:99>
Sets the current VOLUME for the specified output zone
GEQ_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Sets the current GRAPHICAL EQUALIZER status (ON or OFF) for the
specified output zone
GEQ_GAIN
<Zone=ZA:ZD>
<Band=B1:B10>
<Gain=dBx10> Sets the current GAIN (dBx10) of one BAND (B1 to B10) of the
GRAPHICAL EQUALIZER for the specified output zone
XOVER_ACTIVE
<Zone=ZA:ZD>
ON/OFF
Sets the current CROSSOVER FILTER status (ON or OFF) for the
specified output zone
XOVER_TYPE
<Zone=ZA:ZD>
LP/HP
Sets the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
XOVER_FREQUENCY
<Zone=ZA:ZD>
<Frequency=Hz>
Sets the current CROSSOVER FILTER FREQUENCY (Hz) for the