Ecler CA‐NET RS‐232 User Manual
Page 4
CA‐NET Protocol
page 4 / 29
o
OFF
o
INPUTS
o
PRESETS
In the CA40, a single REMOTE port admits the connection of a WPmVOL‐SR unit, which
has a volume control knob and a 5‐position rotary switch, or selector. The selector can
be used in any of these two modes:
o
INPUTS: to select the active audio source(s) (LINE1, LINE2, MICRO,
LINE1_AND_MICRO or LINE2_AND_MICRO)
o
PRESETS: to recall any of the 5 presets in the memory of the unit, which store the
full configuration of the unit, including volumes, EQ, etc.
The factory default working mode of the selector is INPUTS, and it can just be modified
to PRESETS by means of an RS‐232 connection.
In the CA200z there are two independent REMOTE ports, each one able to control one of
the device’s outputs when the CA200z has been configured in the ZONES A/B mode. Each
selector can be used in any of these 3 modes:
o
INPUTS: to select the active audio LINE source (OFF, LINE1, LINE2, LINE3 or LINE4)
o
PRESETS: to recall any of the 5 presets in the memory of the unit, which store the
full configuration of the unit, including volumes, EQ, etc. Just one out of these two
remote ports can be configured to recall presets, not both at the same time
o
OFF: REMOTE port disabled.
<Zone>
are text strings (without blank spaces) that identify a zone where the command will
operate. In the CA200z there are just two possible values for this parameter:
o
ZA (output labeled as ZA or L)
o
ZB (output labeled as ZB or R)
When the <Zone> parameter is not specified, the CA200z will understand the command will
operate over ZA.
<Micro Name>
are text strings (without blank spaces) that identify the MIC inputs in the
unit. In the CA200z there are just two possible values for this parameter:
o
MICRO1
o
MICRO2
<Output Mode>
are text strings (without blank spaces) that identify the amplifier’s output
working mode. In the CA200z there are just four possible values for this parameter:
o
STEREO
o
MONO
o
BRIDGE
o
ZONES
<Zone Label>
is a text string that contains the customized name for a zone that the CA200z
will show in its LCD display. The maximum length for this string is 17 characters, being