EVCO EVCSR338J9 - Manual (Page 33)

EVCO S.p.A. Vcolor 338 S | Installer manual ver. 1.2 | Code 144VC338SE124
page 33 of 50
14.2 Setting the configuration
parameters
Operate as follows to access the procedure:
1. Ensure that the device is switched on and that no
other procedure is in progress.
2. Touch .
3. Touch to select “SERVICE”.
4. Touch the middle of the display.
5. Touch within 15 s to set “-19”.
6. Touch the middle of the display.
Operate as follows to select a parameter:
7. Touch or .
Operate as follows to set a parameter:
8. Touch the middle of the display.
9. Touch or within 15 s.
10. Touch the middle of the display.
Operate as follows to exit the procedure:
11. Touch .
Access to the configuration parameters setting procedure.
Access to the configuration parameters setting procedure.
Selection and setting of a configuration parameter.