Futaba SBE-1 - Manual

WARNING
￸ Ta k e t h e s a m e p ro t e c t i v e m e a s u r e s
against vibration, shock, high temperature,
and the invasion of moisture with the SBE-1 as
you do with the receiver.
s
ADDITION
CAUTION
 Do not connect anything other than an
S-BUS device to the S.BUS output.
s
DAMAGE
S.BUS ENCODER
Instruction Manual
That you for purchasing an
SBE-1 S.BUS *1
encoder.
The
SBE-1 is a converter that is used when using a
CGY750 gyro or other exclusive S-BUS receiver device
with a receiver for conventional system use.
The signals (PWM) of a conventional system of up to 10chs
can be converted to S.BUS system signals.
*1 S.BUS: Standard name of Futaba serial communication for R/C
systems.
[SBE-1 ratings]
07- Æ3"53
s
s
^6
s
EXCLUDING
s
^  #
s
^  #
s07-
* Connects all the connectors corresponding to the
channel necessary to operate the S.BUS device.
* Always connect the CH1 and CH2 connectors.
(To supply power to the SBE-1 and S-BUS device)
s3"53
* C o n n e c t s t o t h e S . B U S i n p u t
connector of an S.BUS device.
Precautions
Name of Each Part and Connection Method
To conventional
system receiver
(up to 10chs)
To S-BUS device
07-
ÆS.BUS Converter
Futaba Corp. will not be responsible for
damages, etc. caused by combination with
other than Futaba Corp. products.
SBE-1
LED (green)
-.
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
©FUTABA CORPORATION 2011, 7 (1)
Note: Always read this manual before using the SBE-1.
Store this manual where it can be used at any time.
[Accessories]
s/UTPUT
*Use this adapter to connect the output connector
to an S.BUS Hub with Cable, etc..
6SHFL¿FDWLRQV DQG UDWLQJV DUH VXEMHFW WR FKDQJH ZLWKRXW QRWLFH
s,%$
3TATE $ISPLAY
No signal Blinking
PWM input Steady light
* Lights when a regular signal is
received on any channel.