Futaba CIU-2 - Manual

USB INTERFACE
Instruction Manual
USB port
Thank you for purchasing a CIU-2.
The CIU-2 is a USB interface for communications between Link supported devices and a Windows
computer.
Connecting and disconnecting the PC and CIU-2
*Windows is registered trademark of Microsoft Corporation.
Notes
s
Drivers and Link programs must be installed.
s
Connection
1.Turn on the PC power.
2.Connect the CIU-2 to the USB port of the PC.
3.When the CIU-2 is first connected to the PC;
the “Found New Hardware Wizard” shown at
the right is displayed. Install the drivers
downloaded from the dealer’ s website.
Disconnection
The CIU-2 can be disconnected even while the
PC power is on. However, do not disconnect
the CIU-2 while it is communicating with a Link
supported device.
s
prohibited.
s
contact us.
s
Specifications
(Specifications and ratings are subject to change without prior notice accompanying technological developments.)
s : USB Rev1.1 compliant
s : USB Series A connector
s
(At connection, idle): 12.3 ±2.0mA
*The PC must have a USB port (Type A).
s
Temperature -10 ~ 50degrees Celsius
s : 18.2 X 56.5 X 9.0 mm
s : 7.5g
s : Windows Vista/XP/2000
*A 500mm extension
cord is supplied with
the CIU-2.