Futaba FBC-I Charger - Manual

Futaba
TRANSMITTER/RECEIVER USE
NICKEL-CADMIUM BATTERY CHARGER
NT-8C(B)
N T - 1 0
N R - 4 G
N R - 4 H
F B C - I
F B C - I
9.6V 500mAH Transmitter use nickel-cadmium battery.
[FP-3E, 4E, other transmitters using 7 penlight
batteries]
12V 500mAH transmitter use nickel-cadmium battery.
[FP-3, 4, FP-2D, 3D, 4D use. cannot be used with E]
4.8V 500mAH receiver, servo use nickel cadmium battery.
4.8V 250mAH receiver, servo use small nickel-cadmium
battery
4.8V 500mAH receiver, servo use nickel cadmium battery.
NR-4C (NR-4G) Charger
NT-8C(B) (NT-10) and NR-4C (NR-4G) Charger
(With 2 charging cords)
N R - 4 C
————— FBC-I USAGE METHOD —————
Connect the charger and nickel-cadmium
battery as shown in the figure.
A red LED will be lighted to indicate that
the battery is being charged.
Be sure that the polarity of the 3P Connector
is correct.
Charging time is 12-15 hours before use.
When not used for an extended period of time,
charge for about 20 hours before using.
Also recharge after more than one week has
elapsed since the last charging.
When completely charged, the battery can
normally be used 8-10 times at about 10
minutes use per time.
A C - 1 1 5V