Futaba FBC-I Charger - Manual (Page 2)

—————FBC-II USAGE METHOD —————
Connect the charger and nickel-cadmium
battery as shown in the figure.
Connect "TX" to the NT-8C(B) or NT-10
(transmitter use) and connect "RX" to the
NR-4C(receiver use).
The LED will be lighted to
indicate that the battery is
being charged.
Be sure that the polarity of
the 3P connector is correct.
Be sure that the TX and RX
charging sockets are correct.
If connected incorrectly,
the receiver use nickel-cadmium
battery will be over-charged
and damaged.
Charging time is 12-15 hours before use. When the battery has not been
used for an extended period of time, charge it for 20 hours before
using. Also recharge the battery after more than 1 week has elapsed
since the last charging.
When fully charged, the battery can be used about 8-10 times at 10
minutes per time.
NT-8C(B) use on the label of the FBC-II indicates 9.6V and NT-10 use
indicates 12V.
————— NR-4G CHAGING METHOD —————
Charge by using the RX side of FBC-I or FBC-II.
The LED of the charger may be somewhat faint when charging the NR-4C,
this is normal and does not indicate trouble.
Charge for 7-8 hours.
When fully charged, the set can usually be used about 4-5 times at 10
minutes/time.
FUTABA CORPORATION OF AMERICA
555 West Victoria Street Compton, California 90220, U.S.A.
Phone:(213)537-9610 Telex:23-0691227 Facsimile: 213-637-8529
FUTABA CORPORATION
Tokyo Office:Daidoo bidg, 3-1-16, Sotokanda, Chiyoda-ku,
Tokyo, Japan.
Phone:(03)255-5881 Telex:J26532