Futaba CIU-2 - Manual (Page 2)

Connection method
1.Connect the CIU-2 to the USB port
of the PC.
2.Connect the Link supported device
to the CIU-2.
3.Connect the batteries by referring
to the Link supported device
instruction manual.
4.Set the power switch of the Link
supported device to ON.
5.Communication with the Link
program is possible.
Example of connection to Link supported device
(The figure below is an example of connection to an MC850C.)
Usage Precautions
Do not disassemble the CIU-2. Do not open the CIU-2 case.
Opening the case may damage the PC board. In this case, PC assembly replacement or repair will become
impossible. There is also the danger of fire and electric shock.
Do not expose the CIU-2 to water or other liquids. Do not touch the CIU-2 when you hands are
wet.
Water droplets entering the CIU-2 may cause trouble. There is also the danger of fire and electric shock.
Do not drop or expose the CIU-2 to strong shock.
It may cause trouble.
Do not set anything on top of the CIU-2.
It may cause trouble.
Do not touch the connectors with your hands. Also, do not connect a dusty or dirty connector.
It may cause trouble.
Handle the PC and peripheral devices in accordance with the instruction manual and cautions
and warnings given in the instruction manual of each product.
Connect to PC USB port
Power switch
Connects the connector of
the Link supported device.
Connect the batteries to
the Link supported device
When connecting, use the accessory 500m
extension cord, as required.
Special Markings
Pay special attention to the
safety at the parts of this
manual that are indicated by
the following marks.
Mark Meaning
Procedures which may lead to a dangerous condition or cause death or serious
injury to the user if not carried out properly, or procedures where the probability of
superficial injury or physical damage is high.
Procedures where the possibility of serious injury to the user is small, but there is a
danger of injury, or physical damage, if not carried out properly.
Symbol: :Prohibited
:Mandatory
<When requesting repair>
Before requesting repair, read this instruction manual again. When there is an abnormality, request repair to your local
Futaba dealer.
©FUTABA CORPORATION 2007,05 (1) FUTABA CORPORATION Makuhari Techno Garden Bldg., B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan
Phone: (043) 296-5119 Facsimile: (043) 296-5124