GTCO 2500 Series - Users Guide 2/3 User Manual
Page 22
Advertising
2500 Series 22
5. Reinstall the selector card. The printed side of the card must face the power cord
connector and the indicator pin must point out.
Changing the Fusing
Tablets operating at 100-125V require one slow blow fuse rated at .25 A.
Tablets operating at 200-250V require two slow blow fuses rated at .125 A.
To change the fusing:
1. Loosen the Phillips screw on the fuse block one turn.
2. Remove the fuse block by lifting it free on of the screw, sliding it away from the
screw and then lifting up.
Invert the fuse block and reinstall it onto the pedestal. Insert the proper fuses into the
holders. (Two fuses are required, although a dummy fuse may be used in the neutral lower
holder.)
Advertising