GTCO DrawingSlate I & II Commands - Manual (Page 2)

Send Data in Margin: If this flag is set, coordinate data point will be sent when it meets the
output conditions in the active area or when in margins.
NOTE: Margins on some of the tablets are very small and large, leaving the table than
coming in to the tablet.
Delta Mode: (mm mode only) Send relative data.
Output Formats: Shows only a sub set of formats for these products.
NOTE: Recommended for use with format 20, 23 or 7 for new drivers.
The following codes are used in describing the output formats:
C
Cn
Cursor Status. In ASCII formats, indicates a single status character.
Cursor Status Bit. In binary formats, a bit representing cursor status.
The highest-numbered “Cn” is the MSB and “C0” for the LSB.
CACB 2 CHARACTER CURSOR STATUS
,
CR
LF
T0
X Y
Xn Yn
pn
pp
+
[-]
ASCII comma.
ASCII carriage return (HEX 0D). CR can be inhibited by CR menu bit.
ASCII Line Feed HEX 0A [LF] is selected by, if enable menu bit.
Tablet status bit 0 or 1 set by command.
Data Digit. In ASCII formats, a numeric character representing
coordinate data. The number of X symbol represents the number of
allowable digits.
Data Bit. In binary formats, a bit representing coordinate data. The
highest-numbered “n” is the MSB.
Pressure pen data 0-7.
Pressure pen data ASCII.
Sign character “space”=pos “-“=neg.
IF NEG IT, ADD A “-“ CHARACTER