GTCO Summagrid IV - Users Guide Part 1 - Manual (Page 22)

Summagrid IV 22
Disabling the Driver
/OFF
Disables driver
4.2.3 Examples
For a Summagrid IV tablet with a 16-button cursor connected to Com 1 in standard
ADI mode, type the following at the DOS prompt:
4.2.4 Configuring AutoCAD for Use with DGMG.COM
After installing the ADI driver, start up AutoCAD and follow the instructions listed
below.
1. If running AutoCAD release 11, select Configure AutoCAD from the AutoCAD
main screen menu and press ENTER to proceed to the configuration menu. If
running AutoCAD release 12, choose Configure from the file dropdown menu
and select ENTER to proceed to the configuration menu.
2. At the configuration menu, choose Configure Digitizer. AutoCAD asks if you
want a new digitizer. Since you’re installing for the first time, type Y and then
press ENTER. A list of digitizer options appear on the screen. If you are running
AutoCAD release 11, select Autodesk Device Interface and press ENTER. If you
are running AutoCAD release 12, choose ADI Digitizer (Real Mode) and select
ENTER.
3. Next, you’re prompted for the hexadecimal interrupt code (INT0XXh)<79>.
Press ENTER to accept the default of 79 and return to the configuration menu.