GTCO Summagrid IV - Users Guide Part 3 - Manual (Page 26)

Summagrid IV 26
Appendix F MM/SummaSketch Format Emulation
The Summagrid IV can emulate the Summagraphics MM/SummaSketch output format.
This chapter provides the binary and ASCII information for the MM/SummaSketch output
format.
F.1
F.1.1
F.1.2
F.1.3
F.1.4
F.1.5 MM/SummaSketch Output Format
Overview
Binary Report Format
ASCII BCD Report Format
MM/SummaSketch Command Summary
MM/SummaSketch Switch Settings 26
26
27
27
30
31
F.1 MM/SummaSketch Output Format
F.1.1 Overview
Summagrid IV report formats conform to MM/SummaSketch standards. To
accommodate the emulation needs, choose either a binary or an ASCII BCD format.
The reports are in counts of resolution.
NOTE: When configuring the Summagrid IV for the default 500 lpi resolution in
binary format, the active area size will be limited to 32.766 inches. If you wish to
utilize the entire active area, you must set the fixed resolution to 200 lpi.