GTCO CR 1212 - Configuration - Manual (Page 6)

Reassembling the Tablet
1. Turn the printed circuit board over so that the component side is not facing you.
Holding the board at an angle, slide the On/Off switch through the cover hole.
Position the board so that the pointed posts are visible through the holes. Gently
push down on the board until it seats on the pointed posts and the standoffs.
The board should slip into this position very easily. If at any time you feel that you had to
force it, then it is not seated properly. Wiggle the board until it drops easily onto the
standoffs.
2. Lining up the holes, replace the metal shield. Insert the shield screw in the center
hole and gently tighten it. Do NOT over tighten.