HONDA 2007 CR-V - Owner's Manual - Manual (Page 109)

To unlatch the detachable anchor,
insert the latch plate into the slot on
the side of the anchor buckle. Store
the detachable anchor and seat belt
latch plates in the retractor housing.
Both front seats are equipped with
seat heaters. The passenger seat is
only has heaters in the seat bottom
because of the side airbag cut off
system. The ignition switch must be
in the ON (II) position to use the
heaters. Push the top of the switch,
HI, to rapidly heat up the seat. After
the seat reaches a comfortable
temperature, select LO by pushing
the bottom of the switch. This will
keep the seat warm.
In HI, the heater turns off when the
seat gets warm, and turns back on
after the seat’s temperature drops.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.
Follow these precautions when using
the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
If the engine is left idling for an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
If equipped
Seat Heaters
Seats, Seat Heaters
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
105
ANCHOR BUCKLE
LATCH PLATE DRIVER’S SEAT
HEATER SWITCH PASSENGER’S
SEAT HEATER
SWITCH
Main Menu Table of Contents