HONDA 2003 CR-V - Owner's Manual - Manual (Page 159)

The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pressing the PWR/
VOL knob, or the AM or FM button.
Adjust the volume by turning the
knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM or
FM button. On the FM band, ST will
be displayed if the station is broad-
casting in stereo. Stereo
reproduction on AM is not available.
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset buttons.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the TUNE knob to the right to
tune to a higher frequency, or to the
left to tune to a lower frequency.
Turn the knob right or left until the
display reaches the desired
frequency.
The SEEK function
searches the band for a station with
a strong signal. To activate it, press
either SEEK button (
or ), then
release it. Depending on which
SEEK button you press, the system
scans upward or downward from the
current frequency. It stops when it
finds a station with a strong signal.
The anti-theft feature will disable the
system if it is disconnected from the
vehicle’s battery. To get the system
working again, you must enter a
code number (see page
). 178
CONTINUED
Operating the Radio
TUNE
SEEK
Audio System
Comf ort and Convenience Features 155
Main Menu Table of Contents