HONDA 2003 CR-V - Owner's Manual - Manual (Page 332)

Your vehicle has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics for the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
If your vehicle’s battery has been
disconnected or gone dead, these
codes are erased. It takes several
days of driving under various
conditions to set the codes again.
If possible, do not take your vehicle
for a state emissions test until the
readiness codes are set. To check if
they are set, turn the ignition ON (II),
but do not start the engine. The
Malfunction Indicator Lamp will
come on for 20 seconds. If it then
goes off, the readiness codes are set.
If it blinks 5 times, the readiness
codes are not set. Refer to State
Emissions Testing for more
information.(See page
.) 351
Malfunction Indicator Lamp
Taking Care of the Unexpected
Readiness Codes
328
Main Menu Table of Contents