HONDA 2001 Passport - Owner's Manual - Manual (Page 191)

5. Block the wheel that is
diagonally opposite the one to
be changed.
6. Loosen, but do not remove,
the wheel nuts by turning the
wrench counterclockwise.
7. There are two jacking points
on each side of the vehicle.
Set the jack in position, as
shown.
Bottom surface of the cross
member at the concave position.
Under the rear axle
housing near the wheel.
Position the jack at the correct
jack point as shown.
Make sure that the jack is
positioned on a level and solid
surface.
Do not position the jack at any
points other than those specified.
In Case of Emergency
REAR
JACK
JACK BAR
JACK HANDLE
FRONT
Main Menu Table of Contents