HONDA 2000 Prelude - Owner's Manual - Manual (Page 191)

Cooling System
Except Type SH only
Remove the drain bolt and washer
from the engine block.
4. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
5. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Except Type SH only
Apply non-hardening sealant to the
drain bolt threads, put a new washer
on the drain bolt, and reinstall the
bolt in the engine block. Tighten it
securely.
Tightening torque:
61 lbf.ft (83 N.m , 8.5 kgf.m)
6. M i x the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
With 5-speed manual transmission:
(Except Type SH)
0.87 US gal (3.3 l , 0.73 Imp gal)
(Type SH)
0.85 US gal (3.2 l , 0.70 Imp gal)
With automatic transmission:
0.85 US gal (3.2 l ,0.70 Imp gal)
Maintenance
DRAIN BOLT
Except
Type SH
DRAIN PLUG HOLDER
RESERVE TANK RESERVE
TANK CAP
Main Menu Table of Contents