HONDA 2000 Prelude - Owner's Manual - Manual (Page 192)

Cooling System
7. Loosen the bleeder bolt on top of
the engine.
Pour coolant into the radiator up
to the base of the filler neck.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
8. Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
9. Check the level in the radiator,
add coolant if needed.
10. Install the radiator cap, and
tighten it to the first stop.
11. Start the engine and let it run until
the radiator fan comes on two
times. Then stop the engine.
12. Remove the radiator cap. Fill the
radiator with coolant up to the
filler neck and the reserve tank up
to the MAX mark.
13. Start the engine and hold it at
1,500 rpm until the radiator fan
comes on. Turn off the engine.
Check the coolant level in the
radiator and add coolant if needed.
14. Install the radiator cap, and
tighten it fully.
15. If necessary, fill the reserve tank
to the MAX mark. Install the
reserve tank cap.
Maintenance
FILLER NECK
Fill up to here
BLEEDER BOLT
Main Menu Table of Contents