HONDA 2000 Prelude - Owner's Manual - Manual (Page 242)

Changing a Flat Tire
9. Locate the jacking point nearest
the tire you need to change. It is
pointed to by a mark molded
into the underside of the body.
Place the jack under the jacking
point. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
resting in the jack notch.
10. Use the extension and wheel
wrench as shown to raise the
vehicle until the flat tire is off the
ground.
11. Remove the wheel nuts and flat
tire. Temporarily place the flat tire
on the ground with the outside
surface of the wheel facing up.
You could scratch the wheel if you
put it face down.
CONTINUED
Taking Care of the Unexpected
JACKING
POINT
WHEEL
WRENCH
EXTENSION
Main Menu Table of Contents