HONDA 2000 Prelude - Owner's Manual - Manual (Page 200)

Spark Plugs
3. Remove the spark plug cap by
pulling it straight out.
4. Remove the spark plug with
a five-eighths inch (16 mm) spark
plug socket.
5. Put the new spark plug into the
socket; then screw it into the hole.
Screw it in by hand so you do not
crossthread it.
6. Torque the spark plug. (If you do
not have a torque wrench, tighten
the spark plug two-thirds of a turn
after it contacts the cylinder head.)
Tightening torque:
13 lbf.ft (18N.m ,1.8kgf.m)
CONTINUED
Maintenance
SPARK PLUG
CAP
Main Menu Table of Contents