HONDA 2000 Prelude - Owner's Manual - Manual (Page 221)

Lights
Replacing a Front Turn Signal
Light Bulb
1. Use a Phillips-head screwdriver to
loosen the turn signal assembly's
mounting screw.
2. Remove the turn signal assembly
from the bumper.
3. Remove the socket from the turn
signal assembly by turning it one-
quarter turn counterclockwise.
4. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
5. Insert the socket back into the
turn signal assembly. Turn it
clockwise to lock it in place.
6. Test the lights to make sure the
new bulb is working.
7. Put the turn signal assembly into
the bumper. Make sure the tab on
the turn signal assembly fits into
the bumper slot. Tighten the
mounting screw.
Maintenance
SCREW
TURN SIGNAL ASSEMBLY
BULB
SOCKET
Main Menu Table of Contents