IC Realtime 4 Channel Forensic Network Video Recorder User Manual
Page 39
30
you want to overlay on the burning record. Check the Check button at the bottom of the
interface, system can auto generate verification information during the burning process. You
can use the verification information to check the data has been tampered with or not. For
detailed CD verification information, you can view chapter 4.1.13.
Figure 4-24
You can click Mark setup button if you want to mark during the burning process.
d) Now you can click Start Sync burning on Figure 4-22 to begin burning.
Note
z
Start sync burning: You can select one or more CD to burning at the same time. System
burns the same data. System stops burning when it finishes burning. Or you can stop
manually.
z
Start tour burning: You need to select several CD to begin circle burning. System begins
burning from the first CD and then auto goes to the second CD until it finishes all CD
burning.
z
Change CD: During the CD burning process, you can click it to replace CD manually.
System pops up current CD and then you can input a new one. System begins burning
data from the previous 5 minutes of the previous CD so that there is no missing data
between these two CDs.
z
Pause: During the burning process, you can pause current burning if the court is
adjournment. Click continue button, you can begin burning again and all data is on the
same CD.
e) Click OK button on the pop-up dialog box, after you complete the burning.
CD Playback
This function is for you to verify the real-time burning data. You can check the real-time
burning data and backup data.
On the preview interface and then right click mouse, select Search.
Or you can go to the search interface, from main menu-search interface.
In Search interface (Figure 4-39), select Play from CD from the dropdown list and then click
file list switch button (Button 5 in Figure 4-39 ). You can see an interface shown as in
Figure 4-41. Here you can view file list from the CD. Double click a file name, you can
playback a file.