IC Realtime 1/3" CCD D1 Weatherproof IR Network Camera with POE (ICIPB580) - Manual (Page 19)

19
3 Installation
3.1 Bracket Installation
Please follow the steps listed below to install the bracket. Please refer to Figure 3-1 for
reference.
 Please line up the installation holes of the bottom of the device to the installation holes in
the front part of the bracket. Then insert the screws to the holes to fasten the device on
the bracket.
 Dig four holes in the wall or the surface, and then input the expansion bolts to the holes
and secure.
 Put the four fixed holes of the bottom of the bracket to the four holes you just dug in the
wall or surface. Put the four fixed screws to the four holes of the bracket and then secure
firmly. Finally you can fix the bracket in the wall or surface.
Figure 3-1
3.2 SD Card Installation
Important
Please unplug the corresponding power cable before the installation.
Please follow the steps listed below to install the SD card.
Step 1