IC Realtime 1/3" CCD D1 Weatherproof IR Network Camera with POE (ICIPB580) - Manual (Page 18)

18
2.5 Alarm Setup
The alarm interface is shown as in Figure 2-7. Please follow the steps listed below for local alarm
input and output connection.
1) Connect the alarm input device to the alarm input port (grey or brown pin of I/O port cable).
2) Connect the alarm output device to the alarm output port (White-pin) and alarm output public
port (Red-pin). The alarm output port supports NO (normal open) alarm device only.
3) Open the Web, go to the Figure 2-7. Please set the alarm input 01 port for the brown-pin (the
1
st
channel) of I/O port cable. The alarm input 02 is for the grey-pin (the 2
nd
channel) of I/O port
cable. Then you can select the corresponding type (NO/NC.)
4) Set the WEB alarm output. The alarm output port of the alarm output 01 device (The white-pin
of the I/O port cable).
Figure 2-7