IC Realtime 1/3" CCD D1 Weatherproof IR Network Camera with POE (ICIPB580) - Manual (Page 26)

26
5 Web Operation
This series IPC product support the Web access and management via PC.
Web includes several modules includes monitor channel list, record search, alarm setup, system
configuration, PTZ control, monitor window and etc.
IP camera factory default setup:
 IP address: 192.168.1.108.
 User name: admin
 Password: admin
5.1 Network Connection
Please follow the steps listed below for network connection.
 Make sure the IPC has connected to the network properly.
 IPC IP address and PC IP address shall be in the same network segment. IPC default IP
address is 192.168.1.108. If there is router, please set the corresponding gateway and
subnet mask.
 Use order ping ***.***.***.***(* IP camera address) to check connection is OK or not.
5.2 Login and Main Interface
Open IE and input IP camera address in the address bar.
For example, if your camera IP is 192.168.1.108, then please input http:// 192.168.1.108 in IE
address bar. See Figure 5-1.
Figure 5-1
System pops up warning information to ask you whether install control webrec.cab or not.
Please click OK button, system can automatically install the control. When system is upgrading, it
can overwrite the previous Web too.
If you can
‟t download the ActiveX file, please check whether you have installed the plug-in to
disable the control download. Or you can lower the IE security level. See Figure 5-2.
Input your IP
address here