Interlogix MCR205-1T/1S User Manual - Manual (Page 28)

22 IFS MCR205-1T/1S User Manual
The SNMP Trap Receiver Configuration Web page includes the following
configurable data:
SNMP Trap Disable or enable the SNMP Trap function, the default mode is
“Disable”.
SNMP Trap
Destination Input the IP address of SNMP Trap Destination.
Cold Start When MCR205-1T/1S executes Cold Start operation, the
administrator PC (SNMP Trap Destination) will receive a Cold Start
Trap.
Warm
Start When MCR205-1T/1S executes Warm Start operation, the
administrator PC (SNMP Trap Destination) will receive a Warm
Start Trap.
Login Fail When Web login fail situation appears on MCR205-1T/1S, the
administrator PC (SNMP Trap Destination) will receive a Login Fail
Trap.
Link Up When TP or Fiber port connection is build up, the administrator PC
(SNMP Trap Destination) will receive a Link Up Trap.
Trap
Event
Link
Down When TP or Fiber port connection is Disconnect, the administrator
PC (SNMP Trap Destination) will receive a Link Down Trap.
Apply Button Press “Apply” button for save current configuration of MCR205-
1T/1S
Factory Default
This function is used to set the MCR205-1T/1S to its factory default settings.
Figure 18: Factory Default Web page screen