Interlogix NS3502-8P-2S User Manual - Manual (Page 37)

IFS NS3502-8P-2S User Manual
37
It recommends using IFS SFPs on the Managed Switch. If you insert a SFP
transceiver that is not supported, the Managed Switch will not recognize
it.
Before connect the other Managed Switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example:
1000Base-SX to 1000Base-SX, 1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
 To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable- with one side
must be male duplex LC connector type.
 To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side
must be male duplex LC connector type.
 Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a
workstation or a Media Converter...
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP
transceiver is operating correctly.
4. Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media
Converters, set the Link mode to “1000 Force” or “100 Force” is needed.
 Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or
through the management interface of the switch/converter (if available) to disable the port in
advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the handle of the SFP module to horizontal.
4. Pull out the module gently through the handle.