Interlogix Simon XT Installation Manual - Manual (Page 25)

Simon XT Installation Manual 19
Function Default setting Required setting
Call waiting Off On if reporting to central station and customer has
call waiting service
Exit extension On On
Swinger shutdown On (one trip) On (one trip)
Fire alarm verify Off On
Duress/panic code Disabled Disabled
Cross zone Disabled Disabled for zones with high probability of false
alarms.
Table 8 below describes nonprogrammable (hard-coded) system operation, as
required to meet ANSI-SIA CP-01, and is provided only for your reference.
Table 8: Nonprogrammable (hard coded) system operation
Function Operation
Silent exit All annunciators disabled
Remote arming exit time and progress
annunciation All annunciators enabled
Abort annunciation Enabled
Cancel report annunciation Enabled
Recent closing Enabled (two minute window)
Exit error Enabled
Restoration of power Panel resumes operation in same arming
state and disregards alarm signals from
sensors for the first 60 seconds after power
restoration
Cancel alarm Enter code only.
Central station reporting
The panel has been tested with the following central station receivers using SIA
and Contact ID reporting formats:
Note: Before beginning installation, installers must verify compatibility with the
following central station receivers.
• Radionics D6600 central station receiver
• Sur-Gard central station receiver with models SG-DRL2A and SG-CPM2
• CS5000 digital alarm communicator receiver