Interlogix Simon XT Installation Manual - Manual (Page 47)

Simon XT Installation Manual 41
2. Enter the dealer or installer code and then press OK.
The display shows Access Codes.
3. Scroll until the display shows Sensors, and then press OK.
The displays shows Learn Sensor.
4. Press OK.
The display shows Trip Sensor ##, with the number signs flashing.
If you wish to use a sensor number other than the next one available, use the
number keys to enter a two-digit sensor number immediately.
5. Press the sensor program button or release the sensor tamper switch.
The display shows SN ## Grp10 <Front Door>, with Grp 10 flashing.
6. Use the number or scroll buttons if you want to enter a new group number;
press OK to accept the group number displayed.
The sensor text flashes.
7. Scroll through the text list, and then press OK to accept the first text segment.
8. You may enter more text or press OK again to finish adding the sensor.
The display shows Trip Sensor ## (with the next available sensor
number).
9. Press Status repeatedly to exit.
To delete a sensor:
1. Scroll until the display shows System Programming, and then press OK.
The display shows Enter Code.
2. Enter your access code and then press OK.
The display shows Access Codes.
3. Scroll until the display shows Sensors, and then press OK.
The displays shows Learn Sensor.
4. Scroll until the display shows Delete Sensor, and then press OK.
The display shows Sn ## Grp## <Text>.
5. Scroll until the display shows the sensor you want to delete, and then press
OK.
The display shows Deleted, and then shows Delete Sensor.
6. Press Status twice to exit.