Philips STU801/05R - Manual (Page 11)

J
3
HOW TO WATCH SATELLITE TV
The following information assumes that your satellite dish and Receiver have ;
been correctly installed. If this is not the case, refer to chapter 4
PERSONALISING YOUR RECEIVER, (page14).
Operation is carried out by use of the remote control. When selecting the
on-screen graphics menus, it will be necessary to use 2 keys which must be
pressed within a timeout period (usually 2 seconds between each key press).
I
This is also true for other multi-key functions.
Switch On
After making all the necessary connections (see section 'HOW TO CONNECT
YOUR RECEIVER'), connect the Receiver, TV and/or VCR to the mains
supply and switch on. Select your ‘Satellite Receiver number’ on your TV or
select the AN input on your TV if you use Euroconnectors. When the mains
supply is first connected, the Receiver will be in standby. To bring the
Receiver out of standby, press the <] or [> key or select a programme
number, using the remote control. You may also use the + or - buttons on the
front of the Receiver.
Switch Off
To ‘power down’ the Receiver, press the (!) key on the remote control or the
Receiver. The Receiver will stay in standby mode as long as the mains supply
is connected.
Note: Your Receiver may have been installed by looping the TV aerial through the Receiver. If
this is the case, the Receiver must always be connected to the mains supply in order to watch
terrestrial TV programmes.
Select a Programme
There are 2 modes of operation, single digit mode and double digit mode.
Pressing the -/- key “toggles” between these two modes.
In single digit mode only programmes 0-9 can be directly entered.
In double digit mode, all programmes can be accessed directly by entering the
appropriate 2 digits. In this mode programmes 0-9 must be preceeded by a 0.
It is also possible to browse through all the programmes using the <□ or [>
keys. The programme ident will be displayed briefly in the top right-hand
corner of the TV screen.
Control Your Philips TV Remotely
At the top left side of your Receiver Remote Control unit is a hidden switch. If
you press this in, and continue to hold it down, your Receiver Remote Control
can act as a TV Remote Control for Philips TV's. You can then change TV
programmes by pressing the programme numbers on the Receiver Remote
Control. This function may not work with some older Philips TV sets.
Permanent Programme Ident Display
It is possible to permanently display the programme ident on your TV screen.
This feature is selected by pressing the MENU key followed by the 8 key.
Repeat MENU, 8 to remove the feature.
Audio Mute
OPERATION
j
o
t>
o
To mute the sound press the key.
The MUTE symbol will appear.
Press again to restore the sound.
Audio Mode
The I-II key is used to cycle through all the audio modes. On certain
programmes it is possible to receive multi-language, stereo or radio
transmissions, e.g. Sky One also transmits Sky Radio in addition to the Sky
One soundtrack. To hear these alternative transmissions, press the I-II key to
select the desired mode.
PH
TVSAI o
GB9