Philips STU801/05R - Manual (Page 22)

FAULT FINDING . FAULT FINDING
6
FAULT
Receiver does not operate
If the Receiver does not give the desired result
I when used
CAUSE AND ACTION
- check the power and connection
- check the satellite dish antenna and/or A/V
connections
- verify that the batteries of the remote control are
not exhausted
- disconnect the receiver from the mains and
reconnect it after waiting several seconds.
Note: You will have to set the internal clock again.
J
Cannot select TV programmes when Receiver
is switched on
With some TV sets it may be impossible to select
a normal TV programme while the Satellite
Receiver is switched on. This may be the case if,
for example, you have your Satellite Receiver
connected to your TV by means of an /W
connector cable and you want to make a record­
ing of a satellite programme while watching a
normal TV programme.
Poor reception
If you have followed carefully the instruction in
section 2 HOW TO CONNECT YOUR
RECEIVER, you should get clear pictures and
sound
If this occurs, you should press the TV/SAT key
on your remote control once.Now you can select
and watch TV programmes.
If you wish to return to the satellite programmes,
press the same TV/SAT key again.
If you have no problem changing TV channels
while your Satellite Receiver is switched on, you
do not need to use the TV/SAT key.
If not, check the section' Modifying Existing
Programmes (Menu 1)' carefully.
- adjust the satellite channel frequency in Menu 1
slightly using the <3 and Q> keys
- check the dish position
If this does not improve things, then the problem
may be due to objects such as buildings or trees
between your dish and the satellite. Ask your
dealer for advice.
Scrolling picture on some programmes
The picture is not stable, scrolls or disappears
and appears all the time. Try to optimise the reception following the
procedure mentioned under Poor Reception. If
this does not give the desired result, you may be
tuned to a programme with conditional access for
which you have no authorisation.
Remote control does not work
If It seems the Receiver does not react to remote
control commands.
If you have any of the faults shown, take the
required action and, if this does not achieve the
required result
- verify that the 9 light is not lit. If so, the
Receiver is switched on to a timer event or is in
sleep timer mode and does not react to remote
control commands.
If you want to stop the sleeptimer, press O.
If you want to cancel the timer event, press the
(I) key quickly followed by VIEW. The timer
event has now been cancelled and the Receiver
will resume normal operation.
- verify that the batteries of the remote control are
not exhausted.
- check that you did not accidentally
reprogramme the Receiver to 'SATT
(see 'Other Remote Controls' in chapter 4)
- consult your dealer
GB 20