Philips STU801/05R - Manual (Page 9)

J
To a TV and a VCR, using coaxial cables CONNECTIONS
d
2 .
3.
4.
5.
7.
8 .
9.
10 .
11 .
12
.
13.
14.
15.
Make the connections as shown in the drawing using the cable
supplied with your receiver.
Connect your Receiver to the mains socket.
Switch your TV ON.
Switch your VCR ON.
Switch the test picture switch on the back of the Receiver to
TEST.
Switch your TV to each of its programme numbers in turn to
check that your Receiver is not causing interference with
terrestrial programmes.
If there is patterning, or any other interference on the screen,
adjust the TUNE control on the back of the Receiver until you
have a clear picture. Only a small adjustment, sufficient to
remove the patterning, should be made at a time.
Continue this procedure until you have checked all the
programme numbers on your TV.
Select a spare programme number on your TV which you will
always use for satellite programmes - this is now your ‘Satellite
Receiver number'. Tune your TV until you find this picture from
the Receiver.
If the reception is poor, use a small screwdriver to turn the
TUNE control on the Receiver until the reception is clear. Go
back to Step 6.
On your TV, select the programme number you use to watch
your VCR.
Select a spare programme number on your VCR which you will
always use for satellite programmes. It is a good idea to use
the same programme number as your TV ‘Satellite Receiver
number’.
Tune your VCR until you find the picture from the Receiver.
If there is patterning, or any other interference on the screen,
adjust the tune control on the back of the Receiver until you
have a clear picture. Only a small adjustment, sufficient to
remove the patterning, should be made at a time.
Now check all the VCR programmes for possible
patterning. Select your Satellite Receiver number on your TV
and check again the TV programmes for possible patterning.
If a problem occurs, go back to Step 7.
Switch the test picture switch on the back of the Receiver to
NORM.
1
GB 7