Philips STU801/05R - Manual (Page 18)

■ The Mechanical Polariser
J
As with the Electro-Magnetic Poiariser, the poiarity settings of the Mechanical
' Poiariser are indicated by a vaiue in the range of 0-63.
Note: If the changes are made to the H-pol Base or V-pol Base in the LNC Offset menu, all 60
Channels will be reset to the new H-pol or V-pol Base setting. Press VIEW In case you decide
not to make any alterations after you have already adapted some parameters.
3. BASEBAND
The baseband output is used to feed an external decoder. This signal falls into
two main categories, PAL or MAC. This option aliows you to switch the
baseband output, provided by the DECODER/DESCRAMBLER socket, to be
either filtered for a PAL decoder or flat for a MAC decoder.
4. AV SOURCE
The Audio and Video source can be seiected from four options:
INT - internal audio and video. In this mode, any external decoder will be
ignored.
AUTO - The default option for most programmes is AUTO so that, if a
decoder providing the correct control signal is used, this decoder wiil be
selected automatically when selecting this programme.
EXT V - Select this option if your decoder only treats the video of an
encrypted programme.
EXT AV- Select this option if your decoder treats both audio and video of an
encrypted programme. This option may have to be selected with some
decoders that do not function if you have seiected AUTO.
Note: If you select EXT V or EXT AV without a decoder fitted, the picture will disappear.
5. DECODER
This option is dependant on the setting of the AV source above.
if AV-source is AUTO, this question wiil be ignored.
If AV-source is INT, you can choose between NONE (normally the case) or
INT. Only select INT if your receiver is equiped with an internal VideoCrypt
decoder with Smart Card reader*.
if AV-source is EXT V or EXT AV, you can now select between EXT 1 or
EXT 2. Only select EXT 2 if you have 2 decoders and the special connector
lead connecting them to your Receiver. Consult your dealer for advice about
this connector lead.
Note: For Receivers without an internal VideoCrypt decoder, the D'/cey on the remote control
has no function.
6. AUDIO
When in the Installation menu, the I-II key or-<] and O keys can be used
to select the sound you want to hear. You may refer to the Satellite Pro­
gramme Guide in the back of this manual to change or optimise your choice.
7. FREQ
Using the <□ and [>■ keys, this option allows you to vary the audio frequency
for both mono and stereo modes, thus enabling you to tune into programmes
using audio frequencies different to the preset ones. MONO V will now show
that it has been altered from its original setting (eg MONO 3). Use this option
to obtain mono sound settings of 6.60 or 6.65MHz (see Satellite Programme
Guide).
8. NAME
The default programme ident can be altered with this option. The <3 and [>■
keys select alphas or numerics and pressing MENU will move the cursor to
the next digit and so on. The (D key will move the cursor back.
9. LNC
Your Receiver has 2 dish antenna inputs, thus allowing you to choose which
satellite dish input you wish to use for each programme. If LNC 1 is selected,
the satellite channel frequency range displayed in option 1 is dependant on
the value asigned to the LNC1 frequency band in Menu 2.
Note: the number displayed does not affect the frequency input range.
•INNOVATRONSA-Ucence
J
AUDIO STEREO A
FREO 7-02 7-20
NAME PR 1
LNC 1
BAND HIGH
PANDA ON
GB 16