Philips STU801/05R - Manual (Page 19)

J
10. BAND i
i
If BAND is selected in the polariser option in Menu 2, then this option will be
i
available. It is intended for use with a dual band LNC.
If LOW is selected, the lower band of the dual band LNC will be activated (e.g.
Astra). The voltage supplied to the LNC will be 14 V.
If HIGH is selected, the higher band of the dual band LNC will be activated
(e.g. DBS). The voltage supplied to the LNC will be 18 V.
When all settings are as required, press the STORE key once to store your
settings. This will bring the WHICH PROGRAMME prompt on screen. Select a
programme number you wish to store this information against using the <I] or
[>> keys or the numeric keys. Press the STORE key again. This will store all
the settings for the programme and put the receiver back into normal mode.
Programmes 59 and 60 have been designated TEST and AUX respectively
and cannot be renamed; consequently the NAME option is not available on
these programmes.
Adding New Programmes (frequency scan)
To add new programmes, it will be necessary to first locate them. This can be
easily done using the frequency scan mode:
PEBSO№LiSINQ
o Press MENU followed by 3.
> The 9 light will start blinking.
l> The receiver will scan for programmes on the polarity you were
last viewing.
When the receiver finds a signal, the scanning speed will automatically
decrease. This allows you the time to stop the scanning by pressing MENU.
Automatically, Menu 1 will be displayed to alter other parameters if necessary,
and to store the channel found under a new preset number. Continue as
described in section “Modifying Existing Programmes (Menu 1)”.
O Press VIEW to quickly end the scan.
To scan for programmes on another polarity it is necessary to select a preset
on this other polarity (see the Satellite Programme Guide). Then press MENU
3 again to re-start the scan.
Other Remote Controls
It is possible to operate your Receiver with a remote control other than the
one delivered with the Receiver. Your Receiver is programmed to function as
“Satellite 2”. The remote control transmits signals in “Satellite 2” codes.
Some multifunctional Philips remote controls have the “SAT” option. If they do
not have the choice between “SAT1” and “SAT2”, they will transmit SAT1
codes. Since your Satellite Receiver is functioning as SAT2, it will not react to
those commands.
But you can change your Receiver from SAT2 to SAT1 and vica versa!
To Change from SAT2 to SAT1:
O Disconnect the Receiver from the mains.
O Reconnect the Receiver to the mains while holding the (*) and
the - button on the front of the Receiver simultaneously for
several seconds.
Now your Receiver will not react to the commands of its own remote control
any more! Use a multifunctional Philips remote control and check if your
Receiver reacts correctly. If this is not the case, follow the procedure below.
To Change from SAT1 to SAT2:
O Disconnect the Receiver from the mains.
o Reconnect the Receiver to the mains while holding the (i) and
the + button on the front of the Receiver simultaneously for
several seconds.
Your Receiver will now resume normal operation with its own remote control.
I
GB17