Vermont Casting NV360 - Manual (Page 10)

10
Vermont Castings Majestic Products NV360/580 Series
20003565
Log Installation
1 . Remove window frame assembly. (Refer to page 10)
2. Remove logs from packaging.
As with all plastics — these are not toys
and should be kept away from children
and infants.
3. Place rear log on rear bracket (ensure log is seated
properly, leveled and centered to the unit), so it will
not move from side to side and is firmly positioned
on the bracket. Be sure log is as far back as possible
on bracket.
Only glass approved for use in Majestic
Fireplaces products may be used for
replacement.
• The use of any non-approved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Under no circumstances should this appliance be
operated without the front glass or with broken
glass. Replacement of the glass (with gasket) as
supplied by the manufacturer should be completed
by a licensed qualified service person.
• Replacement glass (complete with gasket) is
available through your Majestic Fireplaces dealer
and should only be installed by a licensed qualified
service person.
Louvre Removal
To remove louvre
assembly top, pull
louvre up, then lift out.
(Fig. 9) The bottom
louvre assembly is
hinged at the bottom
edge and swings
down.
Operating Instructions
Glass Information
Clamps
Glass Frame
Fireplace
Front
Glass
Panel
Glass
Panel
Pull
Clamp Hook
G584-501
Push
Clamp Handle
Fig. 10 Glass panel removal.
Fig. 9 Remove louvre assembly
top.
1.
2.
Louvre
Assembly
Top
Glass Panel FP444
Window Frame Assembly Removal
1. Shut off gas.
2. Let the fireplace cool if it has been operating.
3. Remove louvre assembly top. (Refer to Louvre
Removal, Fig. 9)
4. Open the bottom louvre assembly.
5. Release the two (2) clamps at the bottom of the
window frame by pulling down on the clamp handles.
6. Lift off the window frame assembly as shown. (Fig.
10)
7. To reinstall window frame assembly follow the above
procedure in reverse.
Glass Cleaning
It is necessary to clean the glass periodically. During
start-up, condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
After the first two weeks of operation, it is
recommended the glass be cleaned two or three times
with a non-ammonia household cleaner and warm
water (gas fireplace glass cleaner is recommended).
After initial use glass should be cleaned two or three
times during heating season.
Clean glass after first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.