Vermont Casting NV360 - Manual (Page 11)

11
Vermont Castings Majestic Products NV360/580 Series
20003565
Lava Rock
The lava rock provided with this fireplace must be
placed on the firebox base around the sides of the
burner assembly and on the tray beneath the grate.
Under no circumstances should this lava
rock be placed on any part of the burner
assembly.
Ember Material Placement
Place the hard ceramic ember material on the burner in
front of the front logs. Place small dime size ceramic
wool on top of hard ceramic embers. Place small pieces
in hole of top cross log and on front of the front logs by
placing a small piece of wool on your fingertip and
pushing it onto the log. Do not place ember material in
the inside corners of the front logs.
LOGS NV360 NV580
Log Front Left B25 E1
Log Front Right B26 E2
Log Rear B27 E3
Log Top Left B28 E4
Log Top Center Left -- E5
Log Top Center Right -- E6
Log Top Right B29 E7
Fig. 12 NV360 log and ember placement.
Log Front
Right
Log Rear
Log Front
Left
Log Top Right
Log Top
Left
LG119
Ember Material
Lava Rock
Top logs must be placed properly onto
notches.
4. Place front left log on top of burner, left side. Align
log's bottom holes with left bracket log locator studs.
5. Place front right log on top of burner, right side.
Align log's bottom holes with right bracket log locator
studs.
7. Place top cross logs onto locator notches. Ensure
logs are secure. (Fig. 11 or 12)
Fig. 11 NV580 log, lava rock and ember placement.
LG120
Log Top
Left
Log Top
Right
Log
Rear
Embers
Lava Rock
Log Front
Right
Log Front
Left
Log Top
Center Right Log Top
Center Left
Flame Adjustment
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the center of the gas control. (Fig. 13
or 14)
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
IH
L O
HV116
Fig. 14 Flame adjustment knob for SIT 820 valve.
Fig. 13 Flame adjustment knob for Honeywell valve.
HV102
LO
HI
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height