Cabletron Systems BRIM E100 BRIM-E100 - Manual (Page 18)

BRIM-E100 User’s Guide Page 3-1
CHAPTER 3
INSTALLATION
This chapter contains instructions for unpacking the BRIM-E100,
installing Fast Ethernet Interface Modules, and installing the BRIM-E100
into Cabletron Systems devices that support BRIM technology.
The following equipment is needed to install the BRIM-E100 and Fast
Ethernet Interface Modules:
• 1 disposable grounding strap (provided with any MIM or hub)
• 1 Phillips screwdriver
3.1 UNPACKING THE BRIM-E100
Unpack the BRIM-E100 as follows:
1. Remove the shipping box material covering the BRIM-E100.
2. Carefully remove the module from the shipping box. Leave the
module in its non-conductive bag until you are ready to install.
3. Attach the disposable grounding strap to your wrist and to a proper
ground. Refer to the instructions outlined on the grounding strap
package.
4. After removing the module from its non-conductive bag, visually
inspect the device. If you notice any signs of damage, contact
Cabletron Systems Technical Support immediately.
!
C AUT IO N
The BRIM-E100 and the host hub are sensitive to static
discharges. Use a grounding strap and observe all static
precautions during this procedure. Failure to do so could result
in damage to the BRIM-E100 or the host hub.
book Page 1 Friday, April 19, 1996 9:53 AM