Cabletron Systems BRIM E100 BRIM-E100 - Manual (Page 34)

The BRIM-E100 Setup Screen
BRIM-E100 User’s Guide Page 5-3
5.2 THE BRIM-E100 SETUP SCREEN
The BRIM-E100 is configured through the BRIM-E100 Setup screen
shown in Figure 5-1. The header of the BRIM-E100 Local Management
screen provides the name of the device in which the BRIM is installed (in
this example it is a MicroMMAC), the flash image version, and the
interface number.
Figure 5-1 BRIM-E100 Setup Screen
The Setup screen displays the following five fields below the header:
Port Type
Displays the current Fast Ethernet Interface Module installed in the
BRIM. The example shown in Figure 5-1 has an FE-100TX module
installed in the BRIM-E100.
Link Status
Displays the current link status as Link or No Link.
BRIM-E100 SETUP
Interface # X
Port Type
Current Operational Mode
Link Status
FE-100TX
[Auto-Negotiation]
Link
SAVE RETURN
166504
Advertised Ability
100Base-TXFD
[100Base-TXFD] [Enabled]
Desired Operational Mode
MicroMMAC Local Management Flash Image Version: XX.XX.XX
book Page 3 Friday, April 19, 1996 9:53 AM